Furthermore, the scattering model and the performance of the glass bead are analyzed, which provides the important basis for designing the optical system of the Laser Doppler Vibrameter. 分析了玻璃微珠的散射模型和性能,为测试系统光路设计提供了重要依据。
The friction coefficient of glass bead filled composite was decreased, wear resistance of the composite was increased, adhesive wear and abrasive wear were main wear behaviors. 结果表明:加入玻璃微珠的复合材料的摩擦因数降低,耐磨性提高,其磨损行为主要是粘着磨损和磨粒磨损;
A conductive and anticorrosive coating was synthesized with modified epoxy resin as bonding agent and silver-coated glass bead as conductive filling. 以改性环氧树脂为黏结剂、银包玻璃微珠为导电填料合成了导电防腐涂料。
Recycled reinforced glass bead system kitchen sheets 再生玻璃小珠强化厨房薄板
Study on the Recipe of Hollow Glass Bead Modified Epoxy Resin Based on the Uniform Design 基于均匀设计的空心玻璃微珠改性环氧树脂配方研究
Preparation and Properties Research of Epoxy Composites Modified by Hollow Glass Bead Treated with Polyurethane 聚氨酯包覆空心玻璃微珠改性环氧复合材料的制备与性能研究
The round rate of this kind of glass bead are as high as90% with very low impurity. 此类玻璃珠的成圆率高达90%以上,杂质含量极低。
Influential factors on the electrical conductivity of silver-coated glass bead/ silicone rubber electrically conductive composite 镀银玻璃微珠/硅橡胶导电复合材料导电性能的影响因素
The utility model is characterized in that a single micro glass bead layer is coated on the peripheral edges of the front side and the back side of the traffic safety satchel. 其特征是在书包正面和背面四周边沿上涂覆单层的微型玻璃珠层。
The voidage of hollow glass bead decreased with increasing fractal dimension of particle size distribution of hollow glass bead. 随着中空玻璃微珠粒度分布分形维的增加,其空隙率减少。
Properties of Hollow Glass Bead Filled PE-HD 空心玻璃微珠增韧高密度聚乙烯的性能研究
The effects of glass bead ( GB) content, diameter and processing route on the mechanical properties of glass bead filled PP and LLDPE were comparatively studied. 采用玻璃微珠(GB)改性聚丙烯(PP)和线性低密度聚乙烯(LLDPE),对玻璃微珠的用量、粒径和复合材料加工方法对材料的力学性能的影响进行了比较研究。
The result shows that glass bead was coated with gold. 结果表明,该玻璃珠表面有金箔涂层。
The Cell-Structure and Properties of Polyurethane Foam Filled with Hollow Glass Bead 空心玻璃微珠复合聚氨酯泡沫塑料的泡孔结构与性能
The relationship of crack extending force, impact rupture time and impact break power with each other for the composites with different glass bead contents and different filler surface treatments was investigated. 在不同玻璃微珠含量和填料表面处理等条件下,研究了裂纹扩展力、冲击断裂时间、冲击断裂功等参量的变化规律和相互关系。
Experimental study on expanded perlite/ glass bead composites 膨胀珍珠岩-玻璃微珠复合制品试验研究
The Izod impact process of PP/ EPDM/ glass bead ternary composite at room temperature was studied. 考察了室温下PP/EPDM/玻璃微珠三元复合材料的冲击过程。
Ultrafine hollow glass bead ( GB) can markedly increase the loss factor of rubber but little effect on the rubber viscosity. 超细的空心玻璃微珠(GB)对橡胶的粘度无明显影响,但提高了橡胶的损耗因子;
Influence of glass bead content and diameter on the mechanical damping of the composite is insignificant; 在相同条件下,最大粒径微珠填充体系的动态模量高于较小粒径微珠填充体系;微珠含量和粒径对复合材料的阻尼的影响不明显;
The tensile Properties of glass bead filled LDPE composites were studied by means of an INSTRON Materials Tester. 应用Instron材料试验机,考察了拉伸过程中玻璃微珠填充LDPE复合体系的力学性能。
Conventional aluminum silicate heat insulation coatings was modified by hollow micro glass bead with high reflectivity. The orthogonal designing was applied to study the effect of emulsions and fillers on the coatings reflectivity. 利用高反射率的空心微珠对传统的硅酸铝保温涂料进行改性,采用正交实验设计,研究了乳液及填料对涂料反射率的影响。
Effects of glass bead surface treatment on the tensile properties of filled LDPE Composites 玻璃微珠表面处理对LDPE复合材料拉伸性能的影响
The results show that the tensile strength increases with increasing the content of the glass bead. 结果表明:填充体系随着玻璃微珠含量增加,拉伸强度增加,冲击强度降低。
Study on thermoplastic polyimide modified by glass bead 玻璃微珠改性热塑性聚酰亚胺研究
Method s Platelet adhesion was determined by using glass bead column method s. 方法通过玻璃柱法测定血小板粘附功能;
The densification of glass bead was studied with different green densities at different temperature to burn out the binde. 用不同密度的玻璃绝缘子生坯,在不同温度下排蜡,研究了玻璃绝缘子的致密化。
The influence of the glass bead size on the material modulus was not too obvious except the individual case. 除个别情况外,微珠粒径对材料模量的影响不太明显。
The cell structure, compression and damping properties of rigid polyurethane foam filled with hollow glass bead were studied. 研究了加入空心玻璃微珠后,硬质聚氨酯泡沫塑料的泡孔结构、压缩性能以及阻尼性能。
The micro-hardness and grain size of steel plates were measured by optical microscope, and the effects of glass bead diameters, shots coverage and shot peening pressure on surface hardness and grains were studied. 通过光学显微镜检测了钢板表层的显微硬度和晶粒尺寸,研究了弹丸直径、表面覆盖率和喷丸压力等参数对表层硬度和晶粒组织的影响。